Pricemate

Lexicomm ViLX-MS-B-Box Master Station Back Box

Lexicomm ViLX-MS-B-Box Master Station Back BoxA back box for the Lexicomm Master Stations.

GBP 233.16

1

Lexicomm ViLX-EX-B-Box System Expander Back Box

Lexicomm ViLX-EX-B-Box System Expander Back BoxA back box for the ViLX-EX8-8 System Expander Panel.

GBP 233.16

1

EMS FC-BATT-BOX-65-BLACK Battery Box Black - For Up To 65ah Battery

EMS FC-BATT-BOX-65-BLACK Battery Box Black - For Up To 65ah BatteryA black battery box for batteries up to 65ah.Key FeaturesColour black

GBP 295.68

1

Lexicomm ViLX-72HR-Box Extended Duration Battery Box

Lexicomm ViLX-72HR-Box Extended Duration Battery BoxMatching enclosure to Lexicomm Master Station allows for extended battery duration where required.Extended length battery lead supplied.Please note the Lexicomm Extended Duration Battery Box requires 1x 12volt 17AH VRSLA battery - this is not included.Click here to order this product.

GBP 304.50

1

EMS IO Box and Chassis Fitted

EMS IO Box and Chassis FittedAn IO box with chassis fitted which is complete with a 2.5A PSU also used to accommodate 2x backup batteries max 9Ah.

GBP 368.68

1

Morley 795-121 DXc Extension Box

Morley 795-121 DXc Extension BoxDXc extension Box increases the enclosure size of a DXc1 Dxc2 or Dxc4 control panel to accommodate larger batteries relays or other equipment by fitting the extension back box 263 x 390 x 147 H x W x D.This Extension Box is supplied without covers. Two covers must be used with the box. Any combination of the three listed below can be used 795-101 795-103 795-116.

GBP 196.91

1

Kentec M608 LUL Red Painted Back Box Only

Kentec M608 LUL Red Painted Back Box OnlyA LUL red painted back box for use with theMWENH6316205P LUL panel.

GBP 247.92

1

Crowcon M02285 Exd IIC Cast Iron Junction Box IP66

Crowcon M02285 Exd IIC Cast Iron Junction Box IP66An Exd IIC Cast Iron Junction Box. IP66 rated.

GBP 277.20

1

Patol 700-525 AnalogueDigital Junction Box - LHDC Through Connector

Patol 700-525 Analogue Junction Box - LHDC Through ConnectorA junction box for the through connection of Patol linear heat detection cable.Key FeaturesStainless steel finishIP Rating IP65

GBP 431.76

1

C-Tec RNU0005319 Box Of 36 Reels Fragile Tape

C-Tec RNU0005319 Box Of 36 Reels Fragile TapeSpares are common across the C-Tec range of products. The RNU0005319 is a box of 36 reels of fragile tape.

GBP 250.25

1

Vesda Xtralis VRT-000 VESDA Remote Mount Box Only

Vesda Xtralis VRT-000 VESDA Remote Mount Box OnlyThe Vesda VRT-000 is a mounting back box which has been designed for use with the Vesda range of remote displays.

GBP 179.04

1

Notifier Semi flush mounting bezel for the Pearl extension back box PRL-BEZEL-16U

Notifier Semi flush mounting bezel for the Pearl extension back box PRL-BEZEL-16USemi-flush mounting bezel for the Pearl extension back box PRL-BOX. H808.5mm x W529mm x D47mm internal aperture H728.5mm x W449mm

GBP 312.31

1

Notifier 020-472 ID2000 ID3000 Series Standard Back Box Kit

Notifier 020-472 ID2000 ID3000 Series Standard Back Box KitBasic back box powder coated in RAL 7021 extra fine texture. Includes power in connectors. Will hold batteries up to 12Ah. Compatible with internal PSU3A or external PSU7A.

GBP 224.70

1

Kentec K41600SGA Surface Back Box for K41300NST or K41300NGR Loop Wired

Kentec K41600SGA Surface Back Box for K41300NST or K41300NGR Loop WiredThe K41600SGA is a Surface Back Box designed for the K41300NST and K41300NGR Type B Outstations.Key FeaturesLoop WiredSurface MountIncludes short circuit isolator

GBP 204.47

1

Patol DTB25 PVC Dirt Trap Box 6900285P

Patol DTB25 PVC Dirt Trap Box 6900285PThe PVC Dirt Trap Box is used as an accessory part for an Aspirating Smoke Detector in areas with high dust content to prevent false alarms and to increase the lifespan of the smoke sensors substantially.When using the dust trap we generally recommend the combination with the large or extra-large filter-box.Due to the Dirt Trap Box design dust particles are deposited on the bottom due to gravity. Smoke particles pass through the Dirt Trap Box unhindered to the small size of the particles. Reliable and fast fire detection is thus ensured.The air polluted with dust particles is also aspirated by the aspirating smoke detector. So that these particles do not cause any false alarms the aspirated air must be purified of these particles.The Dirt Trap Box can be used for this purpose as an additional accessory component. This is then to be arranged in front of the filter-box in the suction pipe see project planning notice.The aspirated air reaches the Dirt Trap Box via the entry opening underneath. En-route to the exit opening above the air is separated from most of the dust particles which are deposited on the bottom of the chamber due to gravity. The gathered dust can be removed during maintenance work simply by opening the lid.Key FeaturesPrevention or substantial reduction of false alarmsLengthening of lifespan of smoke sensorsVery low installation costsSubsequent installation possible at any timeLow operating costsApplicable for all aspirating smoke detectorsQuick clean and inexpensive solution

GBP 232.33

1

Baldwin Boxall BVECASE5BATTC Eclipse5 Battery Box Charger Tray Required If 2xBV3AOM8 Fitted

Baldwin Boxall BVECASE5BATTC Eclipse5 Battery Box Charger Tray Required If 2xBV3AOM8 FittedThe BVECASE5BATTC is a Battery Box Charger Tray for the Eclipse5.Key FeaturesRequired if 2x BV3AOM8 are fitted

GBP 367.42

1

C-Tec EAPBATTBOX EAP Battery Box BS8629 Fits 2 x 12V 38Ahr Battery

C-Tec EAPBATTBOX EAP Battery Box BS8629 Fits 2 x 12V 38Ahr BatteryThe C-Tec EAPBATTBOX is an EAP battery box designed to be compliant with the BS8629.

GBP 323.92

1

Notifier Standard Back-box Extension for ID2000 ID3000 020-508-009

Notifier Standard Back-box Extension for ID2000 ID3000 020-508-009Basic back box powder coated to RAL 7021 extra fine texture. Includes power in connectors. Will hold batteries up to 17Ah. Dimensions 500w x 220h x 122d.

GBP 255.53

1

Elmdene BATT-BOX-65-BLACK Floor Standing 65Ah Battery Box Black with Battery Leads

Elmdene BATT-BOX-65-BLACK Floor Standing 65Ah Battery Box Black with Battery LeadsThis range of switch mode power supplies has been designed specifically for fire systems and are certified to EN54-41997 A12002 A22006.Key FeaturesIntelligent battery charging and monitoring - utilises Elmdene Eco- Charge technologyRemote fault signallingFull rated current to load plus additional current for battery chargingSerial communication available for OEM applications on request3 year warrantyColour BlackPlease note The image is for illustrative purposes only. This product will come in the colour black.

GBP 221.17

1

Notifier Double Extended Back Box Kit for ID2000 ID3000 020-475-009

Notifier Double Extended Back Box Kit for ID2000 ID3000 020-475-009Double extended back-box kit designed for use with the ID2000 ID3000 panels. Space for up to 17Ah batteries.Key FeaturesH840mm W500mm D122mm

GBP 391.81

1

Hochiki SDP-3 Duct Detector Mounting Box Enclosure

Hochiki SDP-3 Duct Detector Mounting Box EnclosureA protective enclosure that can be used to house the SDP-3 Duct Detector Mounting Box to protect it from dust or impact. The enclosure features glanded cable entries and a snap-lock style lid for easy tool-freeaccess.Key FeaturesUse to protect the SDP-3 in situEasy to installCable glands for loop cablingSnap-lock lid

GBP 244.24

1

Baldwin Boxall Battery Box BVOBATT

Baldwin Boxall Battery Box BVOBATTThere are two sizes of Baldwin Boxall External Battery Case depending on the complexity of the installation and the battery size required.Key FeaturesDimensions 410mm H x 290mm W x 200mm DMax weight including batteries 34kg

GBP 416.40

1

Morley 797-078 ZX5e Battery Box

Morley 797-078 ZX5e Battery BoxMorley battery box for the ZX5e intelligent addressable panels. Alternatively can be used as a mounting enclosure.Key FeaturesSize 500 x 500 x 185mm H x W x D

GBP 332.54

1

Aritech External Battery Box for use with PM705C - PM700BAT

Aritech External Battery Box for use with PM705C - PM700BATThis optional battery box to be used with the PM705C accommodates 2 x 38Ah batteries. And ensure long standby times can be achieved when required. The unit comes complete with battery connection cable to be connected to the PM705C.Key FeaturesApproved to EN54-4 VdS certifiedSupport for 38 Ah batteriesTemperature compensated charging

GBP 210.95

1

Notifier Deep Back-Box Extension for ID2000 ID3000 020-509-009

Notifier Deep Back-Box Extension for ID2000 ID3000 020-509-009Deep back box with extra depth for additional battery space powder coated to RAL 7021 extra fine texture. Includes power in connectors. Will hold batteries up to 38Ah Yuasa. Dimensions 500w x 220h x 220d.

GBP 292.03

1

Brand

Merchant

Price (EUR)